Medisana SCR Manual page 14

2. Set-up
GB
2.2
Set-up
12
Remove all parts from the carton and put them on the floor.
We recommend to use an underlying (e.g. carton) in order
to protect the floor, carpet etc.
Install the legs on the bottom part of the seating area as
shown in figure 1 below with 1 screw M6 x 35 and 1 washer.
The legs must be screwed together in the centre crosswise
with the hollows aligned to each other.
1
Washer
Now the two aluminium tubes for the backrest need to be fixed
with 4 screws M6 x 35 and 4 washers (ref. to figure 2).
2
Screws
M6 x 35
Washers
Screws
M6 x 35
Afterwards slide the aluminium tubes of the backrest through
the eyes of the tubes under the seat as shown in figure 3
on next page. Fix the tubes as illustrated with 4 screws M6 x 60.
Screw
M6 x 35