Advertisement
BR8532 BKE260 Kettle IB AUST:Glass Kettle
Operating your Breville Glass Kettle
4. The kettle will automatically switch 'OFF' once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled to the
maximum level. To re-boil it may be necessary
to wait for a few seconds to allow the control
to reset.
5. The kettle should be stored on its power base
when not in use. The power outlet should be
switched off and the power cord unplugged
from the power outlet when not in use.
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do
not pour the water too quickly.
THIS APPLIANCE IS DESIGNED FOR BOILING OF DRINKING QUALITY WATER ONLY. NEVER USE IT
TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID SHOULD ALWAYS BE FIRMLY
IN PLACE AND LOCKED INTO THE CLOSED POSITION BEFORE USE.
8
All manuals and user guides at all-guides.com
2/8/07
10:57 AM
Page 8
continued
Safety boil dry protection
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water. If this occurs
the kettle will stop heating, and the Power On
light will go out. Lift up the ON/OFF switch to switch
it OFF, switch OFF at the power outlet and allow
kettle to cool before refilling.
Remove the kettle from the power base and add
more water. 'Click' sounds may be heard. Then,
return the kettle to the power base. The saftey device
will be reset.
Note
Care and cleaning
Always switch off at the power outlet, and then
unplug the appliance from the power outlet
before cleaning.
Scale filter
The kettle features a mesh filter attached to the lid
that removes scale deposits for cleaner water. To
clean the scale deposits on the filter, fully open the
lid, hold the handle and run it under hot water and
rub with a cleaning cloth or brush.
The concealed element is made from high quality
stainless steel. Any brown stains appearing are
the result of mineral deposits and are not rust.
Note
The filter could become damaged with time, please
check regularly and replace if found damaged.
Note
NEVER IMMERSE THE KETTLE BASE, SWITCH AREA, POWER BASE OR POWER SUPPLY
CORD IN WATER, OR ALLOW MOISTURE TO COME IN CONTACT WITH THESE PARTS.
Removal of mineral deposits
Mineral deposits in tap water may cause the kettle
interior and water gauge to discolour over time. This
may be removed by using a proprietary kettle descaler
which is available from most leading supermarkets,
department stores and hardware stores.
Alternatively:
1. Fill the kettle until
2
⁄
full with 1 part vinegar and
3
2 parts water. Boil and allow to stand overnight.
2. Empty the solution from the kettle. Fill the kettle
with clean water, bring to boil and discard the
water. Repeat and the kettle will be ready for use.
To clean the exterior
The outside of the kettle may be wiped over with
a damp cloth and polished with a soft dry cloth.
Do not use chemical, steel wool, or abrasive
cleaners to clean the outside of the kettle.
Note
Do not place a load on the top of the glass or
knock the glass on a hard surface or drop the
kettle. The glass may break. Always take care
cleaning or filling the kettle.
Note
9
Advertisement
