Connectors And Slots - Biostar A960D+V2 Setup Manual

Motherboard Manual
B. Memory Capacity
DIMM Socket Location
DDR3_A1
DDR3_B1
C. Dual Channel Memory installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
Disabled
Disabled
Enabled
(O means memory installed, X means memory not installed.)
Note: The DRAM bus width of the memory module must be the same (x8 or x16)

2.5 Connectors and Slots

SATA1~SATA4: Serial ATA Connectors
The motherboard has a PCI to SATA Controller with 4channels SATA interface, it
satisfies the SATA 2.0 spec and with transfer rate of 3Gb/s.
IDE1: Hard Disk Connector
The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO
Mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 functionality.
10
DDR3 Module
512MB/1GB/2GB/4GB/8GB
512MB/1GB/2GB/4GB/8GB
DDR3_A1
DDR3_B1
O
X
O
Total Memory Size
Max is 16GB.
X
O
O
Pin Assignment
1 Ground
2 TX+
3 TX-
4 Ground
5 RX-
6 RX+
7 Ground