Husqvarna WS 442 Operator's Manual page 9

6. Push the blade shaft into the cutting arm at the same
time as you rotate the blade carefully. Tighten it with
the supplied 18-spanner. Use tightening torque
70-80 Nm.
WARNING: Make sure that the blade is
correctly attached before you start the
product.
To assemble the blade for flush cutting
WARNING: Disconnect the product from the
power supply before you start the assembly.
1. Remove the outer blade flange and assemble the
blade on the blade flange hub.
2. Make sure the blade is correctly attached before you
start the product.
To attach the blade guard
WARNING: Disconnect the product from the
power supply before you start the assembly.
1. Put the blade guard guide between the rods on the
blade guard.
1094 - 002 - 26.09.2019
2. Lock the plastic heel on the handle to the top rod on
the blade guard.
3. Make sure that the cutting arm is vertical. Lift the
blade guard above the blade and hang the guard in
the blade guard holder on the product. Make sure
the runners on the blade guard are installed in the
slots on the water unit.
4. Pull the handle out of the blade guard and down
against the saw unit. The fastener locks the handle.
5. To remove the blade guard, release the fastener and
pull the handle up and against the blade guard. Lock
the plastic heel on the top rod on the blade guard.
6. Connect the water hose from the outlet on the saw
motor to the inlet on the blade flange hub.
To connect the power pack
CAUTION: Only use the product with an
approved Husqvarna power pack.
9