Husqvarna WS 442 Operator's Manual page 8

To assemble the product on the rails
WARNING: Before you assemble the
product on the rails you must assemble the
product in the saw carriage.
1. Lift the product into position in the saw carriage.
When the product is in position, the lock handle
moves up into a middle position. In this position, the
product stays in the carriage but is not sufficiently
attached to start the work.
2. To attach the product, lift the lock handle against the
product until the handle locks.
3. Use the pin to lock the handle.
To assemble the blade
WARNING: Disconnect the product from the
power supply before you start the assembly.
8
1. Remove dirt from the contact surfaces on the blade
flange and blade.
2. Make sure that the blade rotates with the used part
of the diamond in the rotation direction of the blade.
Note: Because the blade rotation direction can be
selected, the water spray from the blade can also be
selected.
3. Assemble the outer blade flange, blade and blade
flange hub. Use tightening torque 70-80 Nm.
4. Hang the blade with the blade flange and blade
flange hub on the cutting arm.
5. Turn the blade flange hub carefully until it moves into
1 of the tracks in the pivot arm. Attach the blade
flange hub with the bolt.
1094 - 002 - 26.09.2019