Line Card Leds - Cisco Catalyst 9600 Series Installation Note

Table 8: Features Supported on Cisco Catalyst 9600 Series 48-Port 10 G/5 G/2.5 G/1 G/100 Mbps/10 Mbps (C9600-LC-48TX)
Feature
Ports per module
Chassis slot restrictions
Bandwidth per slot

Line Card LEDs

Table 9: Line Card LEDs
LED Type
Blue Beacon
Port Link
Preparing for Installation and Removal of a Line Card
Safety Warnings
Safety warnings appear throughout this publication in procedures that may harm you if you perform them
incorrectly. A warning symbol precedes each warning statement. The warnings below are general warnings
that are applicable to the entire publication.
Warning An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that
no exposed portion of the DC-input power source wire extends from the connector(s) or terminal block(s).
Statement 122
Description
• 48 RJ45 copper ports of 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and
10 Mbps: Provides 48 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and 10
Mbps interfaces by default. These ports can be interchangeably
used as 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and 10 Mbps ports.
• All the 48 ports support 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and
10 Mbps speeds.
C9606R: Slots 1, 2, 5, and 6 only. However, you can install a line
card in any of the supported slots.
2.4 Tbps per slot
LED Position or Colour
Blue
Green
Amber
Off
Cisco Catalyst 9600 Series Line Card Installation Note
Meaning
Module is receiving beacon signal.
Port link is up.
Port link is disabled, that is, administratively down.
No signal is detected, the link is down, or the port is
not connected.
Line Card LEDs
7