C Preparation For Use; Antenna/Cable Connections; Indoor Antenna - Sylvania SSC509D Owner's Manual

Satellite Box or
Cable Box
O UT
(Not supplied)
From
Cable System
75-ohm Coaxial
Cable (Not supplied)
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
NOTE:
Before plugging the an antenna into the ANT. IN jack of the TV/DVD, check that
the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin
into the ANT. IN jack of the TV/DVD.
VHF/UHF COMBINED ANTENNA
A VHF UHF 75 ohm combination antenna can be
connected to ANT terminal.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor
antenna.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to your TV/DVD without a converter box.
Use the TV/ DVD Remote Control to select channels.
The Indoor Antenna (supplied) is detachable. Insert the stem of the antenna into the
hole on the upper-back portion of the TV/DVD. Connect the Indoor Antenna to the
TV/DVD as shown in the diagram. For the best reception, fully extend the Indoor
Antenna and make the necessary adjustments. (Avoid touching the top section when
adjusting.)
NOTE:
The connection of an Indoor antenna may not always give acceptable TV reception.
PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

From Cable System or
IN
Satellite Dish
DC 13.2V
ANT.
L
AUDIO OUT
R
COAXIAL
ANT.
or

INDOOR ANTENNA

VHF/UHF
Combiner
or
(Not supplied)
or
CABLE WITH CONVERTER/DESCRAM-
BLER BOX OR SATELLITE BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown here.
Channel selection must be made with the converter
box or satellite box. This means that channels cannot
be changed using the TV/ DVD Remote Control.
TO VIEW A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the TV/DVD channel selector to the output
channel of the Cable Converter Box or Satellite
Box. (Ex. CH3)
2.Select the channel to view at your Cable Converter
Box or Satellite Box.
– 10 – – 10 –
VHF/UHF Antenna
(Not supplied)
VHF Antenna
(Not supplied)
UHF Antenna
(Not supplied)
Flat twin-lead cable
Bent pin
Cable
Plug
(Needs to be straightened)(Straight pin)
Indoor Antenna
(Supplied)
Flat twin-lead cable
Matching
Adapter
(Supplied)
DC 13.2V
ANT.
L
AUDIO OUT
R
COAXIAL
ANT.
[Fig. 4]
[Fig. 5]
EN
0C28