Cleaning And Maintenance - Kemar KSB-300R Instruction Manual

CLEANING AND MAINTENACE
Disconnect the plug from the mains. Before you clean the device, it should be
sufficiently cooled after use. Do not pour the liquid until it has cooled
sufficiently to avoid scalding. Never immerse the device in water as it may be
damaged.
Clean the parts with a mild detergent and a little warm water. Before you use the parts again,
please dry them off sufficiently. Do not use scouring pads and sponges or aggressive fluids such
as benzine or acetone to clean the device.
Clean the surface of the appliance with a soft cloth or sponge, a little warm water and a mild
dishwashing detergent. Do not immerse the motor base in water.
AUTOMATIC CLEANING WITH THE PULSE FUNCTION
1. Half fill the container with warm water and add a few drops of dish soap or alternatively 1
1/2 teaspoons of liquid bleach to the container.
2. Firmly place the two-piece lid on the container.
3. Press the PULSE button for approx. 1.5 seconds on the display.
4. Press and hold the PULSE button for about 20-30 seconds to clean the container.
5. Turn off the appliance and rinse the container and two-piece lid thoroughly with clean
water. Dry off all parts.
METHODS OF REMOVING MIXTURES IN MIX TANK
Half-fill the blender jar with warm water and add three tablespoons of vinegar essence to the
container. For even better effect, you can add a teaspoon of baking soda. Leave the mixture to
work for about 2-3 hours. Then rinse well with water.
You can fill the blender jug up to half with warm water and add baking powder. Let the baking
soda work for about an hour, then rinse well with clear water.
Alternatively, you can fill the blender jar up to half with warm water and add two to three tablets
of denture cleanser. Let the denture cleaner work for about an hour, then rinse well with clear
water.
An environmentally friendly cleaning can be achieved with the juice of a lemon or citric acid and
two to three tablespoons of baking soda or baking soda. Fill the container halfway with warm
water and add the ingredients. Run mixer for about 10 seconds in PULSE mode. Then pour out
the container and clean the inside walls with a non-scratching soft sponge. Then rinse the
container thoroughly with water. By direct sunlight for a few hours and a little lemon juice or
citric acid, discoloration usually disappears too.
53
DE
KSB-300