KataEX-FM Components and tools Caution • Hand tighten screws only. Do not use power tools. Please review these instructions before beginning the installation. Use the illustrations below to check that all the components needed for your installation were provided with your order. Do not discard the packaging until the product works to your satisfaction. Components and tools clamp or grommet mounting: clamp mounting only:...
Page 3
KataEX-FM Assembly Follow either step #1a for clamp mounting or step #1b for grommet mounting. All other steps apply to both mounting methods. Step #1a: attach base assembly to worksurface — clamp mounting The thickness of the worksurface must be between 0.5" and 2.1". To mount the clamp flush against the worksurface, the thickness must be no more than 1.5".
Page 4
KataEX-FM Assembly Step #2: install monitor arm 1. Rotate the locking ring counterclockwise to unlock it. Remove the locking ring from the connection sleeve. 2. Slide the connection sleeve onto the post with the screw toward the rear. With the sleeve at the desired height, tighten the screw using the 4mm Allen key. 3.
Page 5
KataEX-FM Assembly Step #4: attach monitor to VESA mount • Slide the VESA plate (with monitor attached) back onto the VESA mount. — Make sure the VESA plate clicks securely in place. • OPTIONAL: Secure the VESA plate to the VESA mount using one of the M4x15 set screws, as shown below. set screw 2mm Allen key M4x15...
Page 6
KataEX-FM Assembly Step #6: install lockout set screw(s), if desired Default rotation of the fixed arm and motion arm is 360°. Installation of a lockout set screw limits rotation to 180°. • To lockout rotation of the fixed arm, install one of the M4x15 set screws in the underside of the arm stem. Tighten the screw, then back it off one turn. —...
Page 7
KataEX-FM Assembly Step #8: make any necessary adjustments There are five possible swivel and tilt tension adjustments: 1. Monitor tilt adjustment — Use the 4mm end of the dual Allen key to loosen the screw on the side of the VESA mount to change monitor tilt angle. Tighten the screw to hold the angle. 2.
Page 8
ESI’s option, of the product or any defective part. Costs (such as installation, labor fees or express shipping) incurred due to replacement of products are not covered under warranty. IN NO EVENT SHALL FELLOWES, ITS AFFILIATES, SUBSIDIARIES, RELATED ENTITIES OR THEIR RESPECTIVE OFFICERS, DIRECTORS, OR EMPLOYEES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, EXEMPLARY, OR SPECIAL DAMAGES.
This manual is also suitable for:
Kata ex-fm seriesKataex1-gm-fm seriesKataex1-dc-fm-slvKataex1-dc-fm-blkKataex1-gm-fm-blkKataex1-gm-fm-slv...
Show all