brennenstuhl RC 3600 Instruction Manual page 8

Instructions manual
is off and the switching receiver is ready for op-
eration.
5. The codes are permanently stored, also if the
switching receiver is not connected to the mains.
6. There are 16.777.216 different codes available for
the system that can be attributed at random.
7. To program further switching receivers, do steps
1 - 4 again with the channels B - C.
Deleting Codes
Push the learn button for more than 6 seconds, the
display illuminates quickly 5 times and all codes
saved are deleted. After, the display extinguishes
and a new code can be attributed to the switching
receiver.
Transmitter:
4 x ON/OFF + 1 x all ON/OFF: 4 different channels
and once ON/OFF for all 4 channels
Dimmer Function
Only incandescent lamps and high voltage halo-
gen lamps may be dimmed using the dimmer.
Use with other illuminates, or electrical appli-
ances, can lead to damage to the dimmer or this
appliance.
1. Dim the lamp, by either holding the ON/OFF/dim-
mer button of the receiver, or the ON button of
the transmitter, which this receiver is attributed
to, for more than 1 second. The brightness goes
slowly from brightdark-bright.
2. The brightness last set is saved. When the receiv-
er is switched on next time, the brightness re-
mains as previously saved.
8