Adjusting The Limit Switches - Danaher Motion THOMSON NEFF MULI Series Mounting And Maintenance Instructions

4.1

Adjusting the limit switches

Note circuit diagram of the limit switch.
Fig. 4: Limit switches
No.
1
2
3
4
1. Detach the corresponding clamping ring (1) at the protection pipe (2) by loosening the
mounting bolt (3).
2. Move the limit switch (4) into the desired position.
3. Clamp the ring (1) by tightening the mounting bolt (3).
4. Check the position of the limit switch (4) by turning the screw manually.
5. If necessary, repeat the procedure.
® ®
MULI - JUMBO
Name
Clamping ring
Protection pipe
Mounting bolt
Limit switch
08/05 Assembly
33