Lighting Control With Lutron Caseta - Niles Auriel MRC-6430 System Design Manual

AURIEL MULTI-ROOM SYSTEM DESIGN GUIDE
Installation Requirements
All CAT-5 wiring must be terminated using the T568A wiring convention. The following steps are required to configure the
Lighting system on the MRC-6430 for operation:
1) Connect to the Local Area Network (LAN) on both the MRC-6430 and the SmartBridge Pro.
2) Setup/program the lighting system.
3) Access the Niles Auriel Configuration Wizard for the MRC-6430 through a mobile device, touchscreen or PC/MAC
viewer on the same LAN.
4) Navigate to the Home Control node and configure the lighting system.
5) Configure all connected user interfaces.
Critical Knowledge
The MRC-6430 chassis must be connected to the local area network (LAN).
§
§ The MRC-6430 is defaulted to DHCP and will get an IP address from the LAN router, Touchscreens and mobile devices
will essentially "Plug and Play" when communicating through the same LAN that the MRC-6430 is connected to.
The Lutron Caseta lighting system must be fully programmed and operational before integration with the Niles MRC-
§
6430.
The Niles nTP4 and nTP7 are PoE compliant and may be connected to a PoE network switch, or powered by an
§
external power supply.

Lighting Control with Lutron Caseta

Cable Schedule
QTY CABLE SIGNAL
1 CAT5 Network
1 CAT5 Network
Lighting
Lutron Caseta
Lutron Switch
FROM
Local Area Network Switch
Local Area Network Switch
nTP4
Wireless Router
TO
MRC-6430 Ethernet Connection
Lutron Caseta SmartBridge Pro
nTP7
POE Switch
CAT5
Stereo RCA
Flasher
Speaker Cable
MRC-6430
33