Advertisement
1. Select the maximum temperature on the temperature dial, and wait for the
indicator light to go out.
2. Press the steam button.
3. Wait for a few seconds for the steam to penetrate the fibre before pressing
again.
4. Continued use of this function will cause the iron to cool and the indicator
to light up, in this case wait until the iron is up to temperature again before
continuing.
Troubleshooting
1. Iron does not heat up.
Check the iron is plugged in and the socket outlet is switched on.
Check the fuse
Check the temperature dial is set to the correct setting
2. Iron does not steam.
The water reservoir may be empty, unplug the iron and fill as per the
instructions.
3. Burst of steam does not work.
The water reservoir must be at least ¼ full and temperature must be set to
maximum. Iron should be in the horizontal position and the burst of steam
button must be fully depressed.
Technical Data
Voltage
Rated power
Model Number
Fitting a new plug
The mains lead must be connected as shown below. The wires are
coloured with the following code - Brown wire = Live (L), Blue wire =
Neutral (N), Green & Yellow = Earth (E).
:
220-240V AC 50-60Hz
:
2000 W
:
SDA1025
Connect
Green &
Yellow to
Earth (E
)
Connect
Blue to
Neutral
(N)
Connect
Brown to
Live (L)
Ensure the outer sheath of the
mains lead is securely held by the
cable clamp
Advertisement
