/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 IMPORTANT SAFETY INFORMATION Important Safety Instructions Important Installation Instructions WARNING - TO REDUCE THE RISK OF SEVERE 1. Install the gate operator only when the following INJURY OR DEATH: conditions have been met: •...
/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 Important Installation Instructions (continued) General Safety Precautions Gate Construction For gate operators that utilize a non-contact sensor (photo beam or the like): Vehicular gates should be constructed and installed in accordance with ASTM F2200: Standard Specifica- •...
/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 UL325 Gate Operator Classifications RESIDENTIAL VEHICULAR GATE OPERATOR CLASS I A vehicular gate operator system intended for use in a single family dwelling, garage or associated parking area.
/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 Restrictions and Warnings Gate operator controls must be placed far enough from the gate to prevent the user from coming in contact with the gate while operating the controls. All activating devices must be installed in a clear line-of-sight with the gate and its travel.
/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 Entrapment Protection Internal Entrapment Prevention: This vehicular gate operator is equipped with an inherent (Type A) entrapment sensing device. The system will sense an obstruction in both the open and close cycles, and will reverse the direction of the gate travel upon encountering an obstruction. If the system detects a second obstruction before reaching the full open or close limit after the initial reversal, a warning alarm will activate and the operator will require a reset before resuming normal operation.
/ www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099 Manual Release To manually release the gate operator: TURN POWER OFF. Use the emergency release/shut off only when the gate is not moving. Make sure power for the gate opera- tor is OFF by using the On/Off switch located inside the cover on the left side of the controller.
M o d el F S W 90 0 S w in g Ga te O p e ra to r The FAAC Model FSW 900 is an electro-mechanical vehicular swing gate operator. The direct drive 24V motor allows for smooth start and stop operation, with easy to set limit switches.
Clean the mounting holes and install the sleeves. Position the operator over the anchors. Recheck to make sure the gate and operator are parallel and level with each other. Tighten the anchor bolts to securely hold the operator. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
The Release Handle Nut Plate may be removed to adjust the Release Handle position if needed. Reconnect the plate when adjusted. Attach the top Arm Cap Cover. CORRECT INSTALLATION INCORRECT INSTALLATION www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Connect the AC input wires to the AC terminal located on the bottom/center of the control box. See diagram below. Batteries must be installed after the AC power is on. See Battery Power Connection. GREEN = Earth Gro und WHITE = Neutral BLACK = 120 VAC www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Additional 24 VDC for accessories may be found on the Radio Terminal, Edge/Photo Terminal, and External Loop Terminal. A connection between 24V DC+ and GND will supply power. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Mag / Solenoid Delay Tamper Detect Tamper Detect Soft Start / Hard Start Soft Start / Hard Start Power up the operators and verify that the SLAVE LEDs are blinking www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
To reset the operator in a Hard Shut Down situation: Press the Reset button on the left side of the controller, activate the Reset input or turn the power switch OFF and back ON. Verify proper operation of gate and components www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
The Close and Open safety inputs are monitored OFF: Normal Soft Start, Soft Stop mode. Hard Start Operator starts with 40% motor power for more starting torque. Normal start = 5% motor power www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
SAFETIES Loop Detectors Maglock Light EXTERNAL LOOP DETECTORS Limit Sensor Motor OUTPUTS Radio Master / Slave 24V DC 24-36V DC BATTERY / MASTER / RADIO SOLAR SLAVE www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
NOTE: Dip Switch 1 and 11 change affected inputs to Normally Closed. If there is a fault on the monitored sensor the corresponding LED will not be lit, or it will not blink at the beginning of each cycle. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
NOTE: Dip Switch 1 and 11 change affected inputs to Normally Closed. If there is a fault on the monitored sensor the corresponding LED will not be lit, or it will not blink at the beginning of each cycle. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
The Reset Input can also be used during installation to reset the operator settings. Reset Input: Allows external input to reset gate operator during a Hard RESET Shutdown. Allows external input to reset operator settings during installation. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Fire Input from closing the gate if in the open position. NOTE: Consult your local Fire Department for proper building codes and Fire Lock requirements. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Use one 20 Watt, 24VDC Solar Panel OR two 20 Watt, 12VDC Solar Panels together in series. Connect the Solar Panel positive to SOLAR + Connect the Solar Panel negative to SOLAR - 12VDC, 20 Watt 12VDC, 20 Watt www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
241’ & Up wire. The wire should not move when the sealant has set. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Open Loop: Connect relay wires to OPEN N.O. and GND Set different frequencies for each loop detector. Follow the directions provided by the external loop detector manufacturer for more detailed settings. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Run a new wire on top of the driveway to test the master slave communication. This will determine if the underground wire is good or bad. Possible damage to the control board master slave components. Have boards repaired. www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Neither FAAC S.p.A. nor FAAC International, Inc., shall be liable for any loss or damage whatsoever resulting, directly or indirectly, from the use or loss of use of the product(s). Without limiting the www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80421 / 303-670-1099...
Need help?
Do you have a question about the FSW 900 and is the answer not in the manual?
Questions and answers