Advertisement
LED Indication Lights and Status
LED Indication Lights
Color
State
Green
Solid
Green
Flashing
Yellow
Flashing
Red
Solid
Red
Slow Flash
Red
Fast Flash
Pink
Flashing
Pink
Solid
Blue
Flashing
FCC & IC Notice
We, Nortek Security & Control, LLC of 5919 Sea Otter Place, Carlsbad, CA 92010, declare under our sole responsibility that the device, MMS100 complies
with Part 15 of the FCC rules.
This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference received that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician to help.
WARNING:
•
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
•
Only use this equipment with the provided antenna's, failure to do so will void the user's authority to operate the equipment.
•
This system is for use the Mighty Mule Smart Capable Gate Operator (Model(s): MM371, MM372, MM571, MM572, TS571)
•
A minimum separation distance of 20 cm (or possibly greater than 20 cm) between the antenna and nearby persons should be maintained.
MMS100 Installation Instructions
Connected to router, server & AGO. Normal status.
Connected to router. Not connected to server.
Obtaining IP
Offline. No access point.
Not connected to access point.
User initiated pairing via App.
Connecting and/or checking OTA.
OTA in process.
Connected to router & server. Not connected to AGO.
Telephone Mighty Mule Sales: 1-800-543-4283 • Fax (850) 575-8912
or Mighty Mule Technical Service: 1-800-543-1236 • Fax (850)575-8950
www.mightymule.com
Copyright
©
2019 Nortek Security and Control, LLC.
Status
10023523 A
Advertisement
