Advertisement
3.2.
Trial Operation (after checking Troubleshooting Guide).
3.2.1.
Assembly
• Confirm if there is no gap between housing A and B by pinching lead wires.
• There is no dust or deformation on battery terminals.
3.2.2.
Operation
• Check that each time the switch is pressed, the mode changes as follows: High mode (maximum luminance) → Middle mode
(50% of high mode luminance) → Low mode (10% of high mode luminance) → Off.
• Check that when the LED is ON, holding down the switch turns the LED off.
• Check that the light projecting sections can be rotated (rotating angle: 0° to 270°).
• Check that a click is felt when the light projecting sections are opened/closed.
• Check that a click is felt when the handle is turned.
4
Advertisement
