Advertisement
Quick Links
Lacrosse HDTV Antenna Assembly Instructions
Assembly
1.
Connect coax cable to connection on bottom of antenna
2.
Attach pipe and foot where you plan on installing the antenna
The Lacrosse HDTV antenna is optimized
for digital reception. It has its greatest
performance on the UHF band (ch
14-69) where most of the digital stations
are broadcast. It will also have capability
on upper VHF (7-13) channels as well.
The Lacrosse has very flexible aiming
characteristics with an average beam-
width of 90 degrees.
Advertisement
Summary of Contents for Terrestrial Digital Lacrosse
- Page 1 Lacrosse HDTV Antenna Assembly Instructions The Lacrosse HDTV antenna is optimized for digital reception. It has its greatest performance on the UHF band (ch 14-69) where most of the digital stations are broadcast. It will also have capability on upper VHF (7-13) channels as well.
- Page 2 Attach tilt bracket assembly to back of antenna using screws provided (as shown) Built in Amplifier (Amplified version only) Disregard this step if you have the non amplified version. On the Lacrosse A, There is a built-in low noise pre amplifier. You do not need to run electricity to the antenna.
- Page 3 Caution! Dangerous voltage inside enclosure. To reduce Risk of elec- trical shock Do not remove cover, No use –serviceable parts inside. Refer servicing to qualified personnel. Warning! Installation of this antenna near power lines is dangerous. For your safety, Follow these installation instructions. Questions? Call Terrestrial Digital: 877-825-5572...