kim lighting AFL30 Installation Instructions

AFL30 - Architectural Floodlight Installation Instructions
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
!
Failure to do so may result in serious personal injury.
SAFETY WARNING: To maintain light efficiency and prevent fixture overheating, lenses must be kept
!
clean and free of dirt, dust, leaves, trash and mineral deposits from water. For optimum performance a
regularly scheduled maintenance program should be followed. Fixtures can become very hot. Glass lenses and
metal areas above and around the lamp can become hot enough to blister hands. Particular care should be
taken not to locate fixtures where small children can reach them. Due to the risk of fire, do not aim the fixture
directly towards a wall or foliage within a reasonable distance.
MAINTENANCE: A regularly scheduled maintenance program should be established to retain optimum light
output and reduce heat retention. Dusting with a soft, clean, dry cloth is normally sufficient for the reflector.
Any accumulation of dust or dirt should be removed regularly from both sided of the lens during relamping
(using ammonia water). Do not use alkaline or acid cleaners on reflector surfaces.
LAMP NOTE: All lamps must be rated for "Universal Burning Position" because fixture tilt changes lamp
orientation. DO NOT operate luminaire with missing or damaged lens.
NOTE: All wiring should be done by a qualified electrician. KEEP THIS SHEET FOR FUTURE REFERENCE.
ATTENTION: If your fixture is equipped with a multi-tap ballast and if no voltage was specified on the purchase order,
the ballast has been wired for operation on a 277 volt circuit (347v in Canada). If other than 277 volts is required, i.e.
120v, 208v, 240v, connect incoming voltage lead to selected voltage lead on ballast. Cap off all unused voltage leads.

Tools Required:

(4) J-20 x 3K" Lg. Hex Socket Cap Screws
with Sealing Washer (F Allen Wrench)
Lens Frame
Lens and
Lens Gasket
J" Thick Steel Trunnion
The AFL30 is equipped with a versatile J" thick
steel trunnion bracket. The mounting configuration
is to be determined and maintained by others.

STANDARD MOUNTING INSTRUCTIONS:

Single AFL30 fixture E.P.A.'s =
The fixture mounting means must be designed to adequately support the fixture weight including wind load listed for the
local area.
Note: Kim Lighting assumes no responsibility for fixture mountings designed by others.
Revised 7/16/10 ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
Allen Wrench
3 /32"
Slip Hinge Pins
3.2 (Face-on)
1.9 (45° Tilt)
1.7 (Side)
Status 9
L" Socket and Ratchet
See back of instructions for
mounting dimensions.
AFL30 Maximum Fixture Weight = 80 Pounds
AFL30
Torque Wrench
Housing Gasket
Housing
To install lamp in AFL32;
Loosen philips head screw (2)
places, rotate shield up, install
lamp, lower shield and tighten
screws.
Stop Arm
Ballast Access Cover
Secured by (3) J-20 Hex Socket
Cap Screws (F Allen Wrench)
K-13 Hex Head Trunnion Bolts
(2) C-16 Set Screws
To Lock Fixture Orientation
Part No. 95556