Sylvania ST88245 Owner's Manual page 30

M Storing a Caller ID Number Into a Memory Location
1) Press CID/MENU, and the Caller ID
summary screen appears. The screen
shows the number of new callers and
the total number of callers stored in
Caller ID memory.
2) Press /VOL or
that you would like to store, then press MEM
to store the selection.
3) The Select Memory screen appears.
Use the /VOL or
number (0-9) to select a blank memory
location where you would like to store the
number. (If you want to replace an existing
number with the Caller ID number, skip to step 5.)
4) Press SELECT.
A confirmation tone sounds, and the number is programmed.
5) If you choose to replace an existing number with the Caller ID number,
press SELECT, and the following screen appears.
6) Use the /VOL key to move the pointer
to and press SELECT.
A confirmation tone sounds, and the
number is programmed.
NOTES:
•If you select
•You cannot store a Caller ID message if no phone number appears in
the message.
•If no key is pressed for more than 30 seconds, an error tone sounds, and
the telephone returns to the standby mode.
•If there is an incoming call or page, memory storage is canceled, and the
telephone is set to the incoming call or page.
/VOL to find the number
/VOL keys or enter a
, the Caller ID screen returns.
25