Table of Contents
Advertisement
1.
Please be sure that the batteries in the transmitter are charged
and
If you have a handy microphone unscrew the lower part to open the battery
compartment, where you can put 2 AA batteries (not included). The same
batteries can be inserted in the headset version, by opening the front cover.
Be careful to respect the indicated polarities and remove the batteries from the
devices if you won't use it for a long time.
2.
If you need to connect the receiver to a mixer or an amplifier, use the unbalanced
socket (7) and a cable with jack 6,3 mono connector.
3.
Connect the included adapter to the back socket (8) and then to the 230V
mains.
4.
After turning on the other fixtures of your audio system, press the on/off button
(6) on the base.
5.
If you own the headset version connect the microphone to socket (14). Use the
on/off button (11). Warning: the switch (11) has 3 positions: OFF, MUTE and
ON. Be sure to make two steps and to position it on "ON". The transmitter can
be fastened to your belt thanks to the clip, allowing you to operate handfree.
The headset microphone can be worn behind the neck so that the microphone
will be in front of your mouth. Be careful not to bend the antennas or hide them,
as this could reduce the operative range.
6.
In the same way, if you own a handy transmitter, press the on/off button (11).
For a while the led (10) will light on to confirm it is working correctly. Warning:
the switch (11) has 3 positions: OFF, MUTE and ON. Be sure to make two
steps and to position it on "ON".
8
if
necessary
replace
them
following
the
instructions.
Advertisement
Table of Contents
