Preparation For Welding - Weldy Iberian booster EX2 Operating Manual

Description of tool
3
2
1
1. Welding shoe
2. Hot air tube group
3. Tool rest
4. Welding rod opening
5. Hot air blower
Instruction for tool switch:
• For starting the tool press and hold tool drive on/o switch (10)
• For stopping the tool release tool drive on/o switch (10)
• While holding tool drive on/o switch (10) press locking device drive on/o switch (9) for automatic
mode.

Preparation for welding

Before turn on power supply, all switches have to be turned o and make sure potentiometer is at «0».
The hand extruder must not be operated in infl ammable environments or where explosion hazards
exist. Ensure stable position during operation. The connection cable and the welding rod must remain
unimpeded and must not hinder the user or others during operation.
Ensure power supply voltage is single phase 220V~230V,
with minimum power load capacity of 3000 W.
4
4
11
10
6. Tail handle
7. Drive unit
8. Overload protection fuse
9. Locking device drive on/o switch
10. Tool drive on/o switch
5
8
4
9
12
6
7
4
11. Handle
12. Air temperature potentiometer
13. Hot air blower switch
13
3