Technical Data - Conrad Electronic 1396900 Operating Manual

Assembly
1. Refer to the diagram under "Components/connections".
2. Remove the switching wires from the casing.
3. Drill a hole with a diameter of approx. 12 mm underneath the switching plate into the model train board.
Make sure that there is enough room for both switching wires in the two end positions.
4. Cut out the drilling template in the "Drilling stencil" section.
5. Mark the mounting holes through the two mounting flanges, paying attention to the spatial conditions.
6. Screw the switching wire to the corresponding side of the push rod.
7. Now use 2 screws to mount the points motor underneath your model train installation (with the mounting
flanges pointing upwards towards the model train board). You can make fine adjustments using the fixing
screws, by shifting the switching motor and by using the small lever on the shifting rod.
8. Risk of injury! Make sure that you shorten the protruding length of the shifting wire. The thicker wire may
not be shorter than 25 mm.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

Operating voltage ......................................16 V/AC
Current consumption .................................approx. 1 A
Travel range...............................................approx. 7 mm
Dimensions (W x H x D) ............................23 mm x 21 mm x 67 mm
Weight .......................................................approx. 34 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2015 by Conrad Electronic SE.
Components/connections
Model train board
Mounting flanges
After removing the switching wires, this button can be used to
secure the push rod in the middle for exact mounting.
Drilling stencil
(please cut out)
Holes for switching wire on the right or left, depending on spatial conditions.
Elongated holes or round holes 12 mm in diameter are possible.
V1_1015_02_JH
The connections to the switching station
can be found on the shrunken diodes.
Switching wire
Adjustment rod
Brown
Brown
Red
To the 16 V/AC transformer
Yellow to the core
Blue (right) to the straight track section on the right
Blue (left) to the curved track section on the left
46 mm
12 mm
28 mm
Mounting bores