Eneo VPT-40/24V Installation & Operating Manual page 9

Figure 2
Figure 3
Suspended
Figure 4
Figure 5
V Wiring
A) Pin configuration (solder side of cable connector)
Standard models
4 pins 7 pins
Cardboard
Mounting Disc
(remove after
tightening nuts
on mounting fixture)
Load
Normal
Preposition
models
B) Connector assembly
angle housing (4)
1. Slide parts 1, 2, 3, 4 and 5 over cable outer sheath
2. Remove outer sheath 15mm from cable end
3. Remove each conductor insulation 5mm from its end
4. Solder conductors to socket contacts (6)
5. Draw parts 4 and 5 over cable and screw into contact
body assembly
6. Slide parts 3, 2 and 1 down cable screwing part 1 into
part 4 ensuring good seal by rubber cable sleeve part 3
to cable.
C) The connection lead plug is used to disconnect from the
supply circuit and must be easily accessible at all times.
D) Cable connectors
Standard model
Preposition model
24V Pot
female insert (6)
coupling ring
jacket (5)
gasket (3)
pinchring (2)
pressing screw (1)
Pin Function
1 P/T common
2 Right
3 Left
4 Up
5 Down
6 Heater (when connected)
7 Case ground
1 P/T common
2 Right
3 Left
4 Up
5 Down
6 Heater (when connected)
7
8 Horizontal
9
10
11 Vertical
12
PE Case ground
O-Ring