Closing The Housing; Maintenance Instructions - Eneo VPT-40/24V Installation & Operating Manual

VIII Closing the housing
Attention must be paid when closing the housing that no
wiring is caught between the housing and cover edges.
Torque per screw 1.5~1.7 Nm.
It is essential to ensure that the seal at the edge of the
aluminium profiles and the plastic covers lies flat.
Too high a torque can destroy the stop at the corner of the
covers. Too low a torque leads to leaks.
Platform:
eneo is a registered trademark of Videor E. Hartig GmbH
®
Exclusive distribution through specialised trade channels only.
Videor E. Hartig GmbH
Carl-Zeiss-Straße 8 · 63322 Rödermark/Germany
Tel. +49 (0) 6074 / 888-0 · Fax +49 (0) 6074 / 888-100
www.videor.com
www.eneo-security.com
IX Maintenance instructions
The main rubber gaskets should be replaced after opening
the housing for maintenance purposes to ensure protection
class IP66 / IP65.
Base:
Dimensions: mm
# 990505
Technical changes reserved.
© Copyright by Videor E. Hartig GmbH 07/2012