Handling - Renkforce A-2001 Operating Instructions Manual

Ensure that the tank never runs empty during fog operation. Should this happen nevertheless,
turn the fog machine off immediately using the mains switch POWER (2) and let it cool down.
Refill the tank after cooling. The fill level is evident at the tank fill level display (7).
If no fog emerges, the device is still warming up or reheating (the green indicator LED on the
remote control is not lit).
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a
defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank if the device is not used for any extended period. This prevents leaking of fog
liquid during transport or storage.

8. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation has eva-
porated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains adapter from the mains socket after use.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never touch the device in operation or right afterwards, because this area heats up strongly particularly
in the area of the fog exit opening. There is a danger of burns.
• Never use contaminated fog liquids. Close the tank and the storage container for your fog liquid immedi-
ately after filling.
• Always empty the tank before transporting the device or if you are not using it for a longer period.
• Use only water-based fog liquid. Suitable fog liquids are listed in the „Technical Data" section.
26