Preset Arpeggio Function - Casio Casiotone 1000P Operation Manual

Tvv-'-rr: :
• When the SPLIT Button is pressed on, the note range of
arpeggio will be raised one octave. At this time, the arpeggio
sound and volume can be independently set and adjusted.
(See page 7 for the operating method.)
• During arpeggio playing, the PROGRAM Button indicator
will light up at each first beat of the arpeggio pattern.
When you want to stop arpeggio and perform normal playing, press the PROGRAM
Button off. Even if the Power ON/OFF Switch is turned OFF, the program contents
will be protected by a separate power supply. Arpeggio can be performed at any
time by simply pressing the PROGRAM Button on. Flowever, in the following cases,
the program contents will be deleted.
• When a new arpeggio pattern is programmed. (When the RECORD Button and
PROGRAM Button are simultaneously pressed.)
• When the separate program protection power supply (see page 5) has been de-
pleted.'
• When the PROGRAM Button is pressed in the course of programming.
When no arpeggio has been programmed, if the PRO­
GRAM Button is pressed, the UP/DOWN Button indi­
cator will blink and playing can be performed using the
Preset Arpeggio Function. (See page 20.)
( Programmable Note Pitches and Number of Steps^) * *
|9 note pitches + rests
Sound Selection Button numbers 0 through 9 are used for programming. Since 0 is used for
rests, a pattern of up to 9 kinds of note pitch is programmable.
127 steps
A maximum of 127 steps can be programmed. No dividing is possible.
* While programming, one press of a Sound Selection Button is
counted as one step. The previous example is a four-step program.
When 127 steps have been programmed and another step is at­
tempted," End
MOTS
" will be shown on the digital display.
16
- -
SPLIT
/1 \ -
PROGRAM
//
nm
j>N —^i.
'/ I Y V
UP/DOWN
C _ J
!_ I I U