Woods 605000 Assembly & Operating Instructions page 6

• NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
• NEVER alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void
the warranty.
• ALWAYS perform all recommended maintenance procedures before using your log splitter.
• ALWAYS periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.
• ALWAYS replace all damaged or worn parts immediately.
• ALWAYS be sure that all replacement parts meet manufacturer's specifications.
The hydraulic system of your log splitter requires careful inspection along with the mechanical parts. Be sure to replace
frayed, kinked, cracked or otherwise damaged hydraulic hoses or hydraulic components.
•
NEVER check for leaks of hydraulic fluid with your hand. Fluid escaping from a small hole can be almost invisible.
Escaping fluid under pressure can have sufficient force to penetrate skin causing SERIOUS INJURY or DEATH.
Leaks can be safely detected by passing a piece of cardboard over the suspected leak and looking for discolor-
ation.
•
ALWAYS seek professional medical attention immediately if injured by escaping hydraulic fluid. Serious infection or
reaction can develop if proper medical treatment is not administered immediately.
•
NEVER adjust the hydraulic valve. The pressure relief valve on your log splitter is preset at the factory. Only a qual-
ified service technician should perform this adjustment.
•
ALWAYS be sure to relieve all pressure by shutting off the engine and moving the valve control handle back and
forth should it become necessary to loosen or remove any hydraulic fitting.
•
NEVER operate your log splitter near a flame or spark, or smoke during operation. Hydraulic oil is flammable and
can explode.
•
NEVER move your log splitter without tractor or adequate help.
•
NEVER carry cargo or wood on your log splitter.
•
NEVER allow anyone to sit or ride on your log splitter or tractor.
•
NEVER exceed weight capacity of tractor.
•
ALWAYS confirm 3 point pins are secure with lynch pins in place before lifting or transporting log splitter.
•
ALWAYS have your log splitter attached to 3-point hitch before operating it.
•
ALWAYS allow for added length of your log splitter when turning, crossing intersections and in all transporting situ-
ations.
•
ALWAYS attach to Category I or II 3-point hitch only.
•
ALWAYS replace attachment pins or 3-point hitch components if damaged or excessively worn.
•
ALWAYS have beam pinned down for transport.
Page 6