Alarm Input - Swann SW244-8ML Quick Start Manual

ALARM INPUT

Press + buttons on remote controller to select ALARM INPUT in SETUP menu.
MOTION ALARM OUTPUT
Press + buttons on remote controller to select MOTION ALARM OUTPUT in SETUP menu.
REMOTE CONTROLLER
Press + buttons on remote controller to select REMOTE CONTROLLER in SETUP menu.
If several DVRs are installed, you can control DVRs totally or selectively using one
remote controller. If the DVR has the same DVR ID, it will be controlled simultane-
ously. If you want to control a specific DVR, check the
one DVR ID on DVR ID tab.
36
RECORDING Select recording Channel (1~16 Ch) and record-
CH / QUALITY
ing image QUALITY.
(Normal → Good → Better → Best → No Rec).
Select Channel to display by full screen at alarm
MAIN CH
action (1~16 Ch).
Type TEXT to show on screen at alarm action
MESSAGE
using screen keyboard (Max 15 characters).
Select alarm OUT channel (Alarm out 1~16).
OUT
DURATION Select alarm DURATION time (5 → 10 sec).
Set alarm operating time.(Active time
ACTIVE TIME
window will be appeared.)
MOTION ALARM Select using MOTION detect function or not.
OUT Select alarm OUT channel (Alarm out 1~16).
DURATION Select alarm DURATION time (5 → 10 sec).
ACTIVE TIME Set alarm operating time.(Active time
window will be appeared.)
Select whether to make a beep when
BUTTON BEEP
you press the button on the remote
controller.
ID CONTROL Enable "ID CONTROL" function to
control the selected one by using DVR
ID when several DVRs are installed in
the same place.
Select a number of DVR ID.
DVR ID
ID CONTROL and select