Central Pneumatic 93680 Assembly And Operating Instructions Manual page 4

15. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
16. Replacement parts and accessories. This product is to be repaired and
serviced only by a qualified technician. When this product is serviced, only
identical replacement parts should be used. Use of any other parts will void the
warranty. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
17. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reflexes
are impaired while taking drugs. If there is any doubt, do not operate the tool.
18. Use proper size and type extension cord. If an extension cord is required, it
must be of the proper size and type to supply the correct current to the
compressor without heating up. Otherwise, the extension cord could melt and
catch fire, or cause electrical damage to the tool. Check your air compressor's
manual for the appropriate size cord. It is also possible that the use of an
extension cord may cause your circuit breaker to trip or your panel fuse to break.
If this happens, either use the compressor without an extension cord or find a
larger amperage circuit to use.
19. Maintenance. The maintenance outlined in the "Maintenance" section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualified technician.
20. Compressed air only. Use clean, dry, regulated, compressed air at between 50
and 110 PSI. Never use oxygen, carbon dioxide, combustible gases, or any
other bottled gases a power source for this tool.
21. Do not load brads with the trigger or safety depressed. Unintentional firing
may occur. Do not load brads when the air hose is connected to the tool. Always
assume the tool contains brads.
22. Disconnect air supply before loading the Nailer. Before reloading (or making
any adjustments to) the Nailer, make sure the compressed air is disconnected.
2 3 . Fire brads into an appropriate work surface only. Do not attempt to fire
brads into surfaces too hard to penetrate. Do not double-fire on the same
spot. Do not drive brads on top of other brads, or at too steep an angle. Brads
can ricochet, causing personal injury. Never fire the Nailer into the air, or point it
toward yourself or another person. Always wear ANSI approved impact safety
goggles during use, maintenance, and reloading.
24. Do not fire brads too close to the edge of a workpiece. They may split the
SKU 93680 For technical questions, please call 1-800-444-3353 PAGE 4