Disinfection - Pari MONTESOL Instructions For Use Manual

4.3 Disinfection

Disinfect the components immediately after cleaning (only
parts that have been cleaned can be disinfected effectively).
CAUTION
A damp environment may encourage the growth of bacteria.
Therefore, remove all parts from the pot or disinfector as
soon as disinfection has finished. Dry the parts. The risk of
infection is reduced when the parts are dried completely.
In boiling water
• Place all the individual parts in boiling water for at least
5 minutes.
Use a clean pot and fresh drinking water.
If your water is very hard, scale may be deposited on the
plastic parts as a milky coating. This can be prevented by
using softened water.
NOTICE
Plastic will melt if it comes into contact with the hot base of
the pot. Therefore, make sure there is plenty of water in the
pot. This way you will avoid damaging the components.
Using a standard thermal disinfector for baby
bottles (not a microwave oven)
For effective disinfection, use a disinfector with a runtime of at
least 6 minutes. Regarding disinfection, the duration of the dis-
infection procedure and the quantity of water required for this,
follow the instructions for use of the disinfector you are using.
– 27 –
en