Installing The Stainless Steel Handle; Temperature Control - Pyle Nutrichef PKTEWC Series Manual

INSTALLING THE STAINLESS STEEL HANDLE

For PKTWEC08, PKTWEC12, PKTWEC18, PKTEWCDS1805, and PKTECC40 Models only
This wine cellar includes a stainless steel handle. To install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as shown below in
illustration #1. The gasket can easily displaced by hand, no tools are necessary.
2. Align the handle with the screws installed.Tighten the screws using a Phillips head screwdriver until the
handle sets both flush and secured tightly against the door frame.
(DO NOT over tighten as this will cause damage to the handle assembly).
3. Replace the door gasket to its original position.
1. Gasket
3. Phillips Head Screw
III. TEMPERATURE CONTROL
● It is recommended that the wine cooler should be installed in an area where the ambient temperature is
between 10-26ºC (50-80ºF).
● If the ambient temperature is above or below the recommended ranges, the unit's performance may be
affected, and extreme cold or hot conditions may cause the interior temperature to fluctuate. This will
prevent the optimal range from being reached. In addition, keep in mind that the temperature may
fluctuate depending on whether the interior light is on or off, and whether the bottles are located on
the upper, middle, or lower racks.
RECOMMENDED TEMPERATURES FOR CHILLING WINE
RED WINES
DRY/WHITE WINES
ROSE WINES
PKTEWC08
PKTEWC12
PKTEWC18
PKTEWC80
PKTEWC120
PKTEWC180
PKTEWCDS1802
PKTEWCDS1805
PKTECC40
14 - 18ºC
9 - 14ºC
10 - 11ºC
TEMPERATURE RANGES FOR YOUR WINE COOLER
8-18ºC
10-18ºC
12-18ºC
8-18ºC
10-18ºC
12-18ºC
8-18ºC (Uper Zone)
10-18ºC (Lower Zone)
8-23ºC
2. Phillips Head Screw Driver
4. Handle
46-64ºF (Uper Zone)
54-64ºF (Lower Zone)
5
57- 65ºF
49- 58ºF
51- 53ºF
46-64ºF
50-64ºF
54-64ºF
46-64ºF
50-64ºF
54-64ºF
47-73ºF
www.PyleUSA.com