Braun PT 5010 Manual page 8

Using the appliance
This appliance is perfectly suited for closely and safely removing any
unwanted hair on body and face (e.g. neck, back, eye brows).
Slide the on/off switch (3) up to turn the appliance on.
Place the cutting head (2) against the hair to be removed and guide it slowly
against the direction of hair growth. For optimum results, pull the skin taut
with one hand while using.
The appliance comes with two trimming combs in different lengths for
trimming hair to a uniform length (e.g. eyebrow shaping):
• short trimming comb (6): 5 mm / 1/5
• long trimming comb (7): 8 mm / 1/3
Ensure that the appliance is turned off before attaching a trimming comb.
We recommend that you start with the long trimming comb. Slide it over the
cutting head (2) until it clicks into place.
Turn on the appliance and gently comb your eyebrow against the direction
of hair growth as shown in (b). Ensure that either one of the comb sides is
guided flat against the skin.
Cleaning and maintenance
Always turn off the appliance before cleaning.
Remove the cutting head (2) by turning counterclockwise 90° and then
lifting it up (c).
You can rinse the detached cutting head under warm running water.
Please ensure that the cutting head is complete dry before attaching it.
For storage, attach the protective cap (1).
We recommend lubricating the blade with a drop of light machine oil twice a
year or after cleaning with water.
Subject to change without notice
At the end of their life, empty batteries and the appliance should
not be thrown away with general waste or rubbish. Please dispose of
them at a Braun Service Centre or at an appropriate local collection
point.
8