Instructions Before Installation - Dometic MWE7006 Programming Instructions Manual

MWE7006
5

Instructions before installation

5.1 Painting the sensors
See fig. 2
I
NOTE
The sensors may be painted. The manufacturer recommends
having the sensors painted by a specialist workshop.
5.2 Determining the place of installation for the
sensors
See fig. 3 to fig. 6
I
NOTE
The sensors must be correctly aligned for the device to work
properly.
If they point to the ground, irregularities and bumps on the surface
may be interpreted as obstacles. If they point too far up, obstacles
will not be detected at all.
Note the following during installation:
 The area around the sensors must be free from other objects.
 The distance from the sensors to the ground should be at least 45 cm and
a maximum of 60 cm (fig. 3).
 Note that the installation angle depends on the installation height.
Select the right sensor holder and the appropriate drill diameter by
consulting the table in fig. 3.
 If a bicycle rack has been fitted, then install the sensors at least 30 cm
below it (fig. 4).
Supplement to fig. 6
➤ Observe the intervals between sensors.
I
NOTE
You can also distribute the sensors as shown in alternative B
and C.
EN
Instructions before installation
7