Instructions Before Installation - Dometic MWE4104 Installation And Operating Manual

Instructions before installation

6 Instructions before installation
6.1 Painting the sensors
See fig. 2
I
NOTE
The sensors may be painted. The manufacturer recommends having the
sensors painted by a specialist workshop.
6.2 Determining the place of installation for the sensors
See fig. 3 to fig. 5
I
NOTE
The sensors must be correctly aligned for the device to work properly.
•
Do not install any other attachments in the detection area directly
around the sensor. Attachments in the detection area can lead to
reflections and errors.
•
Do not aim the sensors directly at the ground. If the sensors are
aimed directly at the ground, bumps may be displayed as an obsta-
cle, for example.
•
Do not aim the sensors too far up. If the sensors point too far up,
obstacles will not be detected at all.
Note the following during installation:
• The area around the sensors must be free from other objects.
• The distance from the sensors to the ground when horizontally aligned should be
at least 45 cm and a maximum of 120 cm (fig. 3).
• Note that the alignment of the sensor depends on the installation height.
According to the table in fig. 3, select the sensor holder with the suitable angle.
Supplementary to fig. 5
➤ Observe the intervals between sensors.
I
NOTE
You can also distribute the sensors as shown in alternative B and C.
6
MWE4104
EN