Jaycar LA5155 User Manual

Specifications
LED
Power Supply
Battery Life
Coverage Range
Dimension
Remote Control Function Keys
DISARM
FULL ARM
PARTIAL ARM
FULL ARM + PARTIAL ARM
Remove Tag when Programming
Replace or Reinstall Battery
i. Remove back cover screw and back cover.
ii. Replace or reinstall the CR2032 Lithium coin size Battery from its holder in
the correct polarity as shown.
iii. Replace back cover and tighten the screw.
\
Programming Remote Control Keyfob into your wireless system
[RESET]
Programming Keyfob into Home Automation Controller system, can select input device type Remote Key
or Other, if the Keyfob set other input device type, it will only use for Matrix Action Input condition.
e.g. Setup the detector parameter: input device 3, Remote Key
•
It is accessed directly from Day mode via press [SET] key
•
Press [SET] key will go into Program Mode
LA5155 Wireless Remote Control Keyfob
User Guide
Transmission indication
3V DC (1x CR2032 Lithium Coin size Battery)
Approximate Up to 12 months
Up to 50 meters (line of sight)
61mm x 37mm x 13.5mm
Press once to disarm the system
Press once to arm the system
Press to partial arm the system with partial arm (For selected system only)
Press both buttons at the same time to activate the panic
If the wireless remote control keyfob comes with a
system kit, it has been pre-programmed into the
Control Unit and is not necessary to program it.
You could remove the battery protection tag –
LA5592 Home Automation Controller
POWER
[SET]
[ACTION]
1
alarm
08:00 01- Jan
DAY
08:00 01- Jan
SETUP ACT INFO