McGREGOR MEH4045 Original Instruction Manual page 15

Operate
Operating instructions
2. PAY ATTENTION TO USE YOUR HEDGE TRIMMER
Inspect the area to be cut before each use, remove objects which can be thrown or become entangled
in the cutting blades.
Always hold the hedge trimmer with both hands and with the blade away from you before turning it on.
Always keep the power cord behind the Hedge trimmer when in use. Do not place it over the hedge that
you are trimming where it may be cut by the blade.
When trimming new growth, use a wide sweeping action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before entering the material to be cut.
Always work in the direction going away from people and solid objects such as walls, large stones,
trees, vehicles etc.
If the blade stalls, immediately stop the Hedge trimmer. Disconnect the hedge trimmer from the
electrical outlet and clear the jammed debris from the cutting blade.
Wear gloves when trimming thorny or prickly growth.
Move the hedge trimmer to feed the branches directly into the blade cutting edges.
Do not try to cut stems that are too large to feed into the cutting blade.
TOP EDGING (See Fig D)
Use a wide sweeping motion. A slight downward tilt of the cutting blades in the direction of motion gives
the best cutting results.
D
SIDE EDGING (See Fig E)
When trimming the sides of the hedge, begin at the bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the hedge, resulting in a more uniformed growth.
WARNING!
Never use your tool with a damaged cord since touching the damaged area could cause electrical
shock resulting in serious injury.
If the supply cord is damaged, it should be replaced by a local approved service centre.
E
Check extension cords before each use. If damaged replace immediately.
Customer helpline 0345 605 2065
15