Unloading Procedure - Supra COMP 20 Owner's Manual

Unloading Procedure

1. Make sure that all drain plugs are securely in place.
3. With Bow Eye Hook fastened, retract Boat Buddy
5. Follow the cold start procedure recommended in this
manual.
6. After starting the engine, remove Bow Eye Hook.
7. With engine idling, center steering wheel, engage
transmission and slowly pull throttle into reverse. Ease
NOTE: DO NOT attempt to use excessive power to free
the boat from dry carpet runners. Power off of the trailer
possibly damaging the boat.
Roll driver's side window of tow vehicle down prior to
the driver can escape through open window.
left or right depending on propeller rotation.
© 2007 Skier's Choice, Inc.
Loading Procedure
water with approximately 1 inch of the top of the fender
showing.
the guide poles.
the Boat Buddy and the latch is triggered.
DO NOT Power onto the trailer during rough condi-
tions!
ignition.
DO NOT OVER POWER onto trailer or damage may
occur to the boat and/or the trailer!
The trailer must be positioned for the correct water
depth for loading or you may damage the boat. Varying
positioned in the water. Your local dealer can help you un-
77 —