Acuity LITHONIA LIGHTING Aeris Suspend Series Installation Instructions

Installation Instructions
Aeris Suspend
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING
To reduce the risk of death, injury or property damage from fire, electric shock, cuts,
abrasions, falling parts, and other hazards:
•
Service of the equipment must be performed by qualified service personnel.
•
Installation and maintenance must be performed by a person familiar with the construction and
operation of this product and any hazards involved. All applicable codes and ordinances must
be followed.
•
Read this document before installing, servicing, or maintaining this equipment or installing a
lamp. These instructions do not cover all installation, service, and maintenance situations. If
your situation is not covered, or if you do not understand these instructions or additional
information is required, contact
•
Read and follow all warnings and instructions provided by the lamp manufacturer.
WARNING
Before installing, servicing, or maintaining this equipment, follow these general precautions.
To reduce the risk of electrocution:
To reduce the risk of fire:
To reduce the risk of personal injury from cuts, abrasions, or falling parts:
CAUTION: Observe lamp manufacturer's recommendations and restrictions on lamp operation,
including but not limited to ballast type, burning position, replacement and cycling. Use only lamps that
comply with applicable ANSI standards.
NOTICE: If lamp is marked
Lithonia Lighting, a division of Acuity Brands Lighting, Inc., assumes no responsibility for claims arising out of
improper or careless installation or handling of this product.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
•
Make sure the equipment is properly grounded.
•
Always de-energize the circuit and/or equipment before connecting to, disconnecting
from, or servicing the equipment.
•
Keep material away that can burn from hot lamp.
•
Make sure lamps are correctly installed.
•
Use supply conductors with a minimum installation temperature rating as specified on
equipment.
•
Wear gloves to prevent cuts or abrasions from sharp edges when removing from carton,
handling and maintaining this equipment.
•
Do not use abrasive materials, glass cleaners or other solvents on reflector or lens.
These substances may damage equipment and cause parts to eventually break and
fall.
•
Do not install a damaged fixture.
it contains mercury. Follow disposal laws. See www.lamprecycle.org
SAVE THESE INSTRUCTIONS
Lithonia Lighting Outdoor
One Lithonia Way, Conyers, GA 30012
Phone: 800-279-8041 Fax: 770-918-1209
www.lithonia.com
Lithonia Lighting or your local Lithonia LIghting Distributor.
Part Number: RJ5210199 Rev A
Revision Date: 3/4/08