Advertisement
Kinetix 5100 I/O Terminal Expansion Block
Install the I/O Terminal Expansion Block
Follow these steps to install your I/O terminal expansion block.
1. Wire the I/O terminal expansion block, by using the pinout table on page 3.
The terminal block accepts the following.
Attribute
Wire gauge
Strip length
Torque value
2. To obtain a high-frequency bond between the cable shield and the expansion block and
for stress relief, firmly attach the cable to the expansion block by using a tie wrap (you
supply).
3. Attach expansion block to the I/O connector on the front of the Kinetix 5100 drive by
using a screwdriver and torque to 0.2 N•m (1.77 lb•in).
2
2198-TBIO
1.5...0.05 mm
6...7 mm (0.24...0.27 in.)
20 N•cm (1.77 lb•in)
Rockwell Automation Publication 2198-IN020A-EN-P - August 2019
2
(16...30 AWG)
Route wires such that it limits
stress on cable.
Exposed copper pad is under
cable shield.
Tie Wrap
Advertisement
