Page 1
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 RS-232 Serial Adapter Bluetooth V5.0 BLE Model: S2B5232E 1. Package content: BLE V5.0 RS-232 adapter Package Contents: BLE V5.0 RS-232 adapter x 1 A4 User manual x 1 Mini USB Cable x 1...
Page 3
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 Signal DTE Direction DCE Direction Description Input Output Transmitted data Output Input Received data Ground Output Input Clear to send Request to send Output Input (Default) Power Input (5~27 VDC) 3. Power supply: 3.1 Voltage: 5~40 VDC, Don’t exceed the limit.
Page 4
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 5. GATT Service: 5.1 Architecture: Device Information SetCharacteristicNotification(Char) Firmware Revision String (Char) SetCharacteristicNotification NOTIFY SetCharacteristicNotification(Char) SERIAL writeCharacteristic(Char) RxData writeCharacteristic(Char) BLE_CONF writeCharacteristic(Char) MacID DeviceName writeCharacteristic(Char) DeviceName writeCharacteristic(Char) PinID_Setting writeCharacteristic(Char) Serial BLE Service Mobile APP 5.2 Programming Interfaces: GATT UUID...
Page 5
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 Byte0 Byte1 Byte2 Byte3 Data bit Hwfc Stop Bit Parity Bit 0x01:on 0x02 : No Parity 0x00:off 0x01 : Odd Parity 0x00 : Even Parity Byte4 Byte5 Byte6 Baud Rate Device Mode Reset To Default 00:9600 0x01:on...
Page 6
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 Inquire the current baud rate. BIT= 8 data bit Inquire the current data bit DEFAULT= This command is used to restore the default settings and originate a warm start. Restore the default settings (e.g. 19200 bps). The command will re-start the system for 1 second.
Page 7
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 Inquire the current setting. ROLE= This command is used to specify whether the adaptor is in the central or peripheral role. If the device role is changed, the adaptor will reboot and all paired addresses will be cleared. Set the adaptor to the central role.
Page 8
BLE V5.0 RS-232 adapter user manual V1.0 2018.05.22 when power on. Please reset to the default and follow the above procedures if you want to link with other BLE devices. 8. APP: The APP is used for the configuration and the data transmission test. Setup mode Scan BLE Disconnect...