NOTE: Do not force the tool or apply side pressure to same time. elongate the hole. Let the tool do all the work. Note: XU1 will not be responsible for any damage Removing a Drill Bit or injuries caused by the repair of a tool by an unauthorised person or by mishandling of the tool.
WARRANTY YOUR WARRANTY FORM SHOULD BE RETAINED BY YOU AT ALL TIMES. IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO RETURNING YOUR PRODUCT FOR WARRANTY.
SAFETY GENERAL POWER TOOL or a key left attached to a rotating part of the power tool may result in personal injury. SAFETY WARNINGS INSTRUCTIONS e) Do not overreach. Keep proper footing and balance at all times. This enables better WARNING! Read all safety DESCRIPTION OF SYMBOLS control of the power tool in unexpected situations.
Page 6
ADDITIONAL SAFETY WARNINGS FOR DRILL DRIVERS WARNING! Hold power tool by insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting a ‘live’ wire may make exposed metal parts of the power tool ‘live’ and could give the operator an electric shock.
Page 7
XU1 Power tools 1–23 Letcon Drive, Bangholme, Victoria, Australia 3175 Telephone: 1800 069 486 XLIDS-018 0119...
Page 9
Always replace both carbon brushes at the same time. Removing Impact Bits Note: XU1 will not be responsible for any damage 1. Pull the sleeve of the Chuck forward and remove the or injuries caused by the repair of a tool by an impact bit.
Page 10
WARRANTY YOUR WARRANTY FORM SHOULD BE RETAINED BY YOU AT ALL TIMES. IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO RETURNING YOUR PRODUCT FOR WARRANTY.
Page 11
SAFETY GENERAL POWER TOOL or a key left attached to a rotating part of the power tool may result in personal injury. SAFETY WARNINGS INSTRUCTIONS e) Do not overreach. Keep proper footing and balance at all times. This enables better WARNING! Read all safety DESCRIPTION OF SYMBOLS control of the power tool in unexpected situations.
Page 12
ADDITIONAL SAFETY WARNINGS FOR IMPACT DRIVERS WARNING! Hold power tool by insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting a ‘live’ wire may make exposed metal parts of the power tool ‘live’ and could give the operator an electric shock.
Any other use may result in risk of fire, electric shock or electrocution. Regulatory Compliance Mark (RCM) Only use the compatible XU1 charger to recharge this XU1 battery. Do not place any object on top of the charger or place the charger on a soft surface that may result in excessive internal heat.
Page 14
SPECIFICATIONS CONTROLS WARRANTY Battery Capacity Indicator YOUR WARRANTY FORM SHOULD BE RETAINED BY YOU AT ALL TIMES. IN ORDER TO MAKE A CLAIM UNDER Input Voltage: THIS WARRANTY YOU MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE WITH YOUR There are battery capacity indicators on the battery pack.
Page 15
Any other use may result Transformer energy rating (MEPS) in risk of fire, electric shock or electrocution. Only use the compatible XU1 charger to recharge XU1 batteries. Polarity Do not place any object on top of the charger or place...
SPECIFICATIONS WARRANTY Red light ON: Battery is CHARGING. Green light ON: Battery is FULLY CHARGED. 4.7hours (1.5Ah) YOUR WARRANTY FORM SHOULD BE RETAINED BY YOU AT ALL TIMES. IN ORDER TO MAKE A CLAIM UNDER Charge Time: Green & Red light ON: The surrounding THIS WARRANTY YOU MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE WITH YOUR 5.8hours (2.0Ah) temperature is too high or too low.
Need help?
Do you have a question about the XLDDS-018 and is the answer not in the manual?
Questions and answers