Standard Edition Specifications - Sunfire cinema grand Series II User Manual

Standard Edition Specifications

Power output
225 watts continuous, per channel, all
channels driven into eight ohms,
from 20Hz-20kHz with no more than
0.5% T.H.D.
Power at clipping, minimum:
450 watts per channel into four ohms.
900 watts per channel into two ohms (time
limited basis).
Hum and Noise
-115 dB, A-Weighted
Maximum output current
80 amperes peak to peak per channel
Maximum output voltage
43 volts RMS
Output impedance Front Left
and Front Right channels
Voltage source: Approximately zero ohms
Current source: Approximately one ohm
Input impedance, RCA inputs
24kΩ
Input sensitivity for rated output
Unbalanced: 1.3Vrms
Balanced: 0.65Vrms
Input impedance, XLR inputs
24kΩ, each leg balanced to ground
Female XLR
Pin 1 is ground
Pin 2 is positive (hot)
Pin 3 is negative (cold)
12VDC Trigger Inputs
Input voltage range 5VDC-18VDC
Impedance: approx 600Ω (20mA @ 12V)
Power Consumption
45W At idle
200W Typical (1/8th power)
1800W Absolute Max (Fuse Limit)
Dimensions
17.0 inches wide
5.9 inches high (including feet)
16.7 inches deep (to tips of connectors)
Weight
32 lbs
Finish
Brushed aluminum and black anodize
© 2001 Sunfire Corporation.
All rights reserved. Sunfire Corporation
reserves the right to improve its products at
any time. Therefore, specifications are subject
to change without notice.
Manual part number : 913-040-00 Rev A
Standard Edition Specifications
User's Manual
9