Advertisement
1. Introduction
◼ This LED Dusk-to-Dawn luminaire uses the latest in solid-state lighting technology for
long life, low maintenance and high efficiency.
◼ This luminaire can be installed with a shorting cap (available from your electrical distributor)
in lieu of the supplied photocell for control by an external switch or time clock relay.
◼ The solid-state driver allows operation on nominal 100V-277V, 60Hz AC supply without any
variation in light output.
◼ Suitable for use in the following locations:
• Min. Ambient Temp: -4°F (-20°C)
• Max Ambient Temp: 104°F (+40°C)
• Suitable for wet Locations
1. Installation
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed,
inspected, and maintained by a qualified electrician, in accordance with all applicable
electrical codes.
Warning:
To avoid electric shock:
•Be certain electrical power is OFF before and during installation and maintenance.
•Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
To avoid explosion:
•Make sure the supply voltage is the same as the rated luminaire voltage.
•Do not install where the marked operating temperatures exceed the ignition temperature of
the hazardous atmosphere.
•Do not operate in ambient temperatures above those indicated on the luminaire.
•Ensure lens is tightly closed when in operation.
Use electrical wire rated for at least 194°F (+90°C) for supply connections
Note: Save these instructions for future reference.
ILP – Industrial Lighting Products, LLC
519 Codisco Way, Sanford, FL 32771
Phone: (407) 478 3759 Fax: (407) 478 3760
www.ilp-inc.com
INSTALLATION INSTRUCTIONS
LED DUSK-TO-DAWN
November 5, 2014
Advertisement
