Advertisement
TO INTERCONNECT the lamp to an automation system, two #16 AWG wires (not
supplied by Strong) must be installed as illustrated on the Interconnection Diagram. These wires must
be shielded to prevent interference in the theatre sound system.
NOTE: Lamp ignition in "AUTO" mode is effected by a sustained dry contact closure between
terminals 3 and 6. DO NOT apply voltage to these terminals. Refer to instructions furnished by the
manufacturer of the automation controller.
TO OPERATE with an automation system, place the MODE switch in the "AUTO"
position, and the LAMP switch to "ON." When the xenon power supply is energized, the lamphouse
POWER light will glow, and the blower will operate. The bulb will not ignite until provided a dry
contact between 3 and 6 by the automation controller. Opening this contact will extinguish the bulb,
and allow the POWER light and the blower to continue to operate.
IN THE EVENT of an automation failure, manual control of the lamp can be restored
by placing the MODE switch in "MAN." and switching "ON or "OFF" with the LAMP switch.
AUTOMATION SYSTEMS
U80/013
Advertisement
