Spod BANTAM Operational Instructions

BANTAM
OPERATIONAL INSTRUCTIONS
Revision 2.0
GET TO KNOW YOUR BANTAM
1. Positive battery cable connection
2. DIP switches (see page 2)
3. Negative battery cable connection
4. Mounting hardware
5. Accessories terminal block for switches 5-8
6. Input terminal block (see page 3)
7. Jumper for input polarity selection (see page 3)
8. Controller inputs (Ethernet cable)
9. 2AMP fuse for circuit board protection
10. Cover. Do NOT remove or warranty will be voided
11. Accessories terminal block for switches 1-4
12. Reverse polarity warning light (lights Red if reverse polarity is detected)
13. Thumb screw for lid fastening
14. Place holders for switch ID labels
15. Auxiliary port identifications
1
12
11
10
9
PAGE 1
3
2
8
7 6
NOTES AND WARNINGS
•
Never reverse polarity on battery cables.
•
NEVER chassis ground the sPOD's
negative battery cable. Always attach both
positive and negative accessory wires to
the sPOD.
•
Any modifications to any of the sPOD wire
harnesses will void the warranty.
•
Although the sPOD system is weather
proof, do not submerge in water. Do not
spray cleaner onto unit or into any
openings. Always use a soft towel or cloth
for cleaning purposes and or compressed
air to dry.
•
System will shut down when voltage drops
to 11.2 V (2 minute delay) and requires 12.8
V to reinitialize (start engine).
•
Do not tamper, open or remove any
factory-installed components; this will void
the warranty.
•
Do not replace 2 amp fuse with any other
rated fuse; this will void the warranty.
•
Do not attach any additional electrical
accessories to the battery terminals on the
Bantam; this will void the warranty.
•
The Bantam does not require the use of
Relays or Fuses unless the accesory
attached draws more than 30AMPS
•
The Bantam employs self healing circuits.
In the event of a short/overload, the circuit
will shut off. Correct the short/overload,
then cycle the switch on and off to reset.
4
5
14
13
15
WWW.4X4sPOD.COM