Table of Contents
Advertisement
2 Caring for your Edbike bike and pre-use checks
Your Edbike bike has been thoroughly tested at the factory prior to delivery, and undergone a pre-
delivery inspection by your Edbike Stockist.
It is very important that you check the bike thoroughly before its first use. Equally important are
frequent and regular spot-checks, as they will protect you and your Edbike bike.
Please read this manual carefully.
2.1 Before you set off for the first time
2.1.1
Check the handlebars and handlebar stem are properly tightened.
2.1.2
Check all other nuts, bolts and fixings are properly tightened.
2.1.3
Check brakes are functioning properly.
2.1.4
Check tyre pressures are correct and tyres are not damaged.
2.1.5
Check reflectors and lights if fitted, are functioning properly.
2.1.6
Make sure the battery is fully charged.
2.1.7
Load the battery into bicycle and turn on with the switch . To remove the battery, turn the
battery key anticlockwise to "off" then press inwards and continue to turn until the battery
slides out.
2.1.8
Turn on the bike by pressing the on/off switch adjacent to the left hand grip for two
seconds. (Turn off the bike by repeating the same process).
Fig 1
The bike will be ready to ride and the LCD will activate showing battery state, assist level,
time, trip and speed. Turning the pedals for more than ¼ of a revolution or twisting the
throttle (if fitted) will now activate the motor.
Advertisement
Table of Contents
