Advertisement
Location and Function of Parts
Rear panel
1
1 ANT IN (antenna input) A/B terminals
Use to connect the antenna for wireless tuner. When
installing the tuner unit, connect the optional UHF
antenna AN-820A.
Note
Before locating and connecting the antenna, read carefully the
instructions supplied with the antenna.
Incorrect location of the antenna may cause a bad reception
such as intermittent sounds. If it is not easy to relocate the
antenna after location, check carefully if the performance will
be satisfied with the location.
Use the coaxial cable of impedance 50 ohms/75 ohms (5D-FB,
5C-2V, etc.). The cable can be extended up to about 50 m with
5D-FB, and up to about 25 m with 5C-2V.
2 Tuner unit slot (MIC1, MIC2)
These are for installation of the optional wireless
tuner unit WRU-806A. Up to two units can be
installed. (Refer to page 9 and page 10)
Before installation, read carefully also the instructions
of WRU-806A.
6
2
8
9
0
5 6
3
4
!¡
!™
!£
!¢
!∞
3 REMOTE terminals
CONTROL S input terminal
Connect to the S output terminal of another equip-
ment.
When this terminal is plugged in, the sensor of this
unit is not functioning.
Input signals are directly output from control S output
terminal.
CONTROL S output terminal
This terminal outputs the signal input from CON-
TROL S input terminal or the sensor.
RS-232C (serial input/output) terminal
This model can be controlled by the external controll
equipment through this terminal using a null modem
cable.
Terminal
Electrical specification : Based on RS-232C standard
Recommended cable
Cable length
Pin No.
1
2
3
4
5
6
7
8
9
For protocols, please consult your dealer.
7
!§
: D-sub 9 pin, male,
inch type screw
: Multicore shielded cable for
data communication
: 15m or under
1
5
6
9
Signal
Function
N.C
Not connected
RD
Received data
TD
Transmission data
ER
Data terminal ready
SG
Signal line grand
DR
Data set ready
RS
Transmission request
CS
Transmission approval
N.C
Not connected
!¶
- Quick Links:
- Specifications
Hide quick links:
Advertisement
