Advertisement
Installation
The Komando™ Rotating Dual Lens Dash Cam2 is designed for windshield mounting
Power & Charging
This unit is powered by a rechargeable lithium-ion battery. There are two ways to charge the dash
cam.
A. At home
You can charge the dash cam at home by using the included microUSB cable. Just connect
one end to the camera and the other to a computer or USB wall block. If using a wall block,
ensure the output is not more than 5V.
B. In your vehicle
Connect the dash cam to your cars 12V output using the included cable. When powering on
your vehicle, the unit will automatically power on. When you power down your vehicle, the
Dash Cam will take up to 5 seconds to power off and automatically save the previously
recorded file.
It is recommended that you always use the original charger. Some vehicles have constant power
flowing from the outlet. In this case, you must long press the power button on your Dash Cam to shut
it down.
Note: Constant power while in use is recommend for your Dash Cam. Because of the internal
software and applications this device features, the battery power is limited when not plugged in.
Some vehicles do not have constant power to their DC outlet when not in use. If your Dash Cam is
left in the vehicle without constant power use of the Dash Cam will be limited
Menu Settings
Power on your unit, stop the recording and hit the Menu button. This will bring you to the menu
options. Use the UP and DOWN buttons to navigate the menu options, use the Screen Toggle
button (# 6 in the diagram) to change menus, and press OK to make a selection. There are 4 main
menus: Movie Mode Menu, Still Capture, Media Tool, and General Settings.
Movie Mode Menu
Volume: Adjust the system volume
Movie mode: 1920 x 1080p 30fps | 1280 x 720p 60fps | 1280 x 720p 30fps | 640 x 480
30fps
Movie quality: Super fine and Fine
Movie clip Time: 25min, 10min, 5min, 3min, 2min, 1min, and off.
Motion Event REC: 5 Seconds ,10 Seconds (The default), 30 Seconds and 1 Minute
Sound Record: On (Default), Off
LDWS: On, Off (Default) (Lane Departure Warning System). You must activate the LDWS to
receive beep notifications of lane departure
FCWS: On, Off (Default) (Front Car Warning System). You must activate the FCWS to receive
beep notifications of front car warning
Operating Instructions
Advertisement
