Install Disks - NETGEAR ReadyNAS RR4360X Quick Start Manual

Install Disks

Install at least one, and up to 60, disks before powering on your ReadyNAS for the first time.
If you install previously formatted disks, you must use your ReadyNAS to reformat them the
first time you power on the system. For information about reformatting disks, see Reformat
Disks on page 10.
Note: Reformatting disks deletes all data on the disks.
When you power on your system for the first time or if you reset your system to its
factory default settings, the optimal RAID mode and level are automatically selected for
you based on the number of disks that are installed. If desired, you can later change the
RAID settings manually. For information about RAID settings, including changing RAID
settings, see the ReadyNAS OS 6 Software User Manual. A link to this manual is available at
www.netgear.com/support/product/ReadyNAS_OS_6 or through a link in the product's user
interface.
¾ To install your disks:
1. Pull the chassis forward so that panel on the top front of the chassis is clear of the rack.
2. Press the front pair of release buttons on the sides of the chassis and push the top cover
toward the front until you can lift it off.
7