Before using for the first time
Activating the cooker hood
The hob and cooker hood must be
switched off.
Touch the run-on control for
approx. 10 seconds until 1 lights up.
Then touch in turn,
– the 1 control,
– then the B control,
– then the lighting control .
The cooker hood is now in signing on/
off mode.
If a wireless connection has not yet
been established, 2 and 3 will flash at
the same time.
If a wireless connection has already
been established, 2 and 3 will light up
constantly (Con@ctivity 2.0 is already
activated or a remote control is signed
on).
22
Touch the B control to activate
Con@ctivity 2.0.
2 will light up constantly, 3 will flash on
and off.
After a few seconds 2 and 3 with light
up constantly, B will flash on and off.
The search for a wireless connection
will start.
Activating the hob
While the cooker hood is searching
for a signal, start activating the hob.
More information about this can be
found in the Operating instructions
for the hob.
When the hob registers that
connection has been established,
confirm activation on the cooker
hood with the run-on option control
515. All indicators will go out.
Confirm activation on the hob.
Con@ctivity 2.0 is now ready to use.
If you do not confirm within 4 minutes,
activation will not take place.
You only need to carry out the
activation procedure once. If the
appliances are disconnected from the
electricity supply, during a power cut
for example, they will still remain
activated.